Basic Tutorial on STAAD Pro V8i SS6 version

-

Just the introduction & basic of Staad Pro V8i SS6 version
Tutorial No 1


Comments

  1. Aptron Gurgaon4 May 2021 at 07:14

    Thanks for Sharing this Information. Staad Pro Institute in Gurgaon

    ReplyDelete
  2. APTRON Delhi3 June 2022 at 23:09

    Staad Pro course in Delhi

    ReplyDelete
  3. Shailendra16 July 2022 at 02:42

    STAAD Pro course in Gurgaon
    https://techplanet.today/post/best-staad-pro-training-institute-in-gurgaon
    Staad Pro is now one of the most popular and commonly used Software for Structural Analysis and Design by Civil Engineers all over the World. Learn Staad Pro Course in Gurgaon at an affordable fee with job placement.

    ReplyDelete

Post a Comment

Popular posts from this blog

Design of a singly reinforced concrete beam as per IS 456:2000

-
Image
Design of a singly reinforced concrete beam Example: Design of a singly reinforced concrete beam for the following data.           Clear Span of the beam – 3 m           Width of supports – 200 mm           Working live load – 6 KN/m           Grade of concrete – M20           Grade of steel – Fe-415 HYSD bars Solution: Given Data –   f ck  = 20 N/mm 2 .                         f y    = 415 N/mm 2 .                                                 Load factor = 1...
Read more

Concrete Mix Design M25 SCC [IS CODE]

-
In order to determine the mix design quantities of different ingredients for a particular grade of concrete, few steps are required which are as follows: 1.        Determine the target compressive strength The target compressive strength can be calculated by the following formula                                 T fck = T cs + 1.65 SD ……… [IS CODE: 10262-2009]                  Where, T fck is the target compressive strength of concrete.                              T cs is the compressive strength of concrete.            ...
Read more

Classification of columns

-
Image
  Types of columns & their properties Structural Concrete member in compression are generally termed as columns & strut. The term column is used for structural member transferring loads to the ground. As per Indian Standard Code IS 456:2000 clause 25.1.1 defines the column as a compression member whose effective length exceeds three times the least lateral dimension. Whereas pedestal is termed as vertical compression members whose effective length is less than three times its least lateral dimension. Axially loaded columns may fail in any one of the following modes: Pure Compression failure- Where the column generally fails due to the axial load & Buldge at the center of the unsupported length. Combined Compression & bending failure- Where the column generally fails due to the combined effect of axial load & bending due to the presence of beams.   Failure by elastic instability. These modes generally depend on the slenderness ratio of ...
Read more